Errors of the Atlant refrigerator make it possible to understand the cause of the breakdown. If your model is with an electronic control system, you will find fault codes on the display. Their decoding is in the operating instructions and in the table below. Having learned the meaning of the code, you will find the problem and can fix it yourself.
Error codes of the Atlant refrigerator
What to do if the technique gives an error? First of all, reboot the system: disconnect from the network for 10-15 minutes, then look at the display again. Did the icons disappear from the screen? So, the reason is a system failure. If it is highlighted again, then it's time to study our table.
Malfunction code | What does it mean | How to fix the problem |
F1 | In electronically controlled refrigerators, the air sensor does not work. | Check wiring and tightness of the sensor contacts. Replace part if broken. |
F2 | There is no signal from the evaporator sensor. | Inspect the wiring loop from the main module to the sensor for damage. Check your contacts. Install serviceable parts. |
F3 | The sensor does not work in the freezer compartment. | Diagnose and replace broken parts. |
F4 | Insufficient mains voltage: below 170 volts. | You need to wait until the voltage is restored. Experts recommend installing stabilizers on large equipment. |
F5 | Overvoltage in the network: above 260 Volts. When the voltage is exceeded by 10%, the control board shows an F5 error to protect the components of the refrigerator from combustion. | The problem will not be fixed by the service center wizard. Preventive work in electronic networks will help, replacing wiring in the house. Also installation of a stabilizer. |
F6 | The two-chamber refrigerator received a malfunction of the refrigerator compartment motor. | If the equipment has completely stopped working, diagnose the electronic module:
Need to repair a defective item. |
F7 | Damage to the compressor of the freezer department. | |
Flashing L | The freezer or refrigerator is set too low. | Adjust the thermal relay. |
Flashing h | The temperature in the cells is exceeded. |
The reasons for the appearance of the error H should be discussed separately. Situations that do not require repair:
- Leaky compartment door. Press her down harder.
- Randomly turned temperature controltoo high value.
- If you checked the first two points, but H continues to flash, defrost the refrigerator for at least 24 hours.
What else could cause the code:
- The lamp does not turn off when the door is closed. Then she begins to heat the interior of the camera. It is necessary to check and replace the switch, clean the contacts.
- Loading a large number of products. Wait about half an hour until they cool and the microclimate is restored in the compartment.
It is not recommended to put hot dishes in the refrigerator. This will lead to condensation and the formation of ice on the walls.
- Deformation, wear, contamination of the seal on the door. You can restore the shape of the sealant with hot water: pour the rubber in a thin stream. You can clean it with a soapy solution. If worn, the element must be replaced.
- Broken socket, pulling plug. Check your network connection.
When a specialist is indispensable:
- Freon gas leak. Inspection of the system through which the refrigerant circulates: capillaries, valves, filters. If the capillary tube is in oil, this indicates a leak of chaladagent. It is necessary to eliminate the leak and refuel the system with gas.
- Motor Compressor Problems. If you notice that the compressor works without stopping and does not turn off for rest, carry out a diagnosis.
- Capillary blockage. Need to clean the system.
Do not panic when a code appears on the display. Problems can be fixed by calling the wizard or by making your own efforts.