The modern Euronova washing machine (Eurosoba), like other machines, provides a self-diagnosis system. This system finds breakdowns and issues error codes on the electronic scoreboard.
The user, understanding what the code means, can often fix the problem himself, without resorting to the services of specialists.
If an error appears on the board, SM Euronov’s work is blocked, and often the code does not disappear from the screen even after a reboot. To remove the error, you need to do this:
- Turn the selector dial to the “Asterisk” position.
- Turn the switch to the P2 mark “Cold”.
- Clamp two buttons at once - the second and third . Hold your fingers on the buttons until the code disappears from the display.
- If an error reset occurs, the combination “00” will appear on the display, which means that the machine is ready for use.
- If the machine again gives an error when starting the washing programs, it needs to be repaired.
Next, we will consider what to do if the Euronov machine shows an error, and how to eliminate the malfunction that caused it.
Eurosoba washer error table: what does it mean and how to fix it
Error code | Description of the problem | Possible causes of SM failure Euronova (Eurosoba) - for models 1100 Sprint, 1100 Sprint + |
F1 | The machine is turned on, but does not erase. | If the error F1 is on, there can be three reasons for this:
|
F2 | Disrupted operation of the SMA drain system. There is either no discharge or the water leaves too slowly. | What to do with error Ф2:
|
F3 | Failure of the filling system. Water is not poured into the tank at all or is collected too slowly. | How to fix the appearance of error F2? If the fault is caused by low pressure in the water supply system, normalize the water pressure. Other causes of failure:
|
F4 | Damage to the filling system: too much water is collected, after which the washing does not start. | In the F6 error, the following factors may be to blame for the breakdown of the filling system:
|
F5 | Damage to the heating system of a Eurosoba washing machine. The wash is in cold water. | In the event of an F5 error, only two breakdowns can be involved:
|
F6 | It also says a malfunction in the heating system. Water does not heat up during washing. | When the AGR shows F6 on the display, then:
|
F7 | Damage to the drain and filler systems. The tank is full, water spills out of it. | If F7 is displayed on the scoreboard, then:
|
F8 | Damage to the electric motor. The motor does not rotate at all or rotates at insufficiently high speeds. | With an F8 error, you can diagnose such breakdowns:
|
F9 | Failure of the electric motor. The engine spins too fast, exceeding the permissible speed. | With code F9, there are 2 possible causes of failure:
|
F11 | The machine does not start when you select any washing mode. | There are at least 4 reasons that could cause the appearance of the F4 error code on the scoreboard:
|
FC | Damage to the drain system. The machine stops work, while leaving water in the tank. | FS lights up on the AGR screen in such cases:
|
Fault codes on the screen of your Euronov washing machine will always help you figure out the problem - keep a sign for yourself so that it is at hand.